|
|
|
|
|
|
|
|
|
|
|
|
|
|
ProSportHD Generation 4 On-Board Marine Battery Chargers incorporate all-digital microprocessor control. The ProSportHD Series provides unique automatic installation feedback with its exclusive "System Check OK" and individual "Battery Bank Trouble" LED indicators which eliminate time consuming troubleshooting by clearly indicating system and battery connections are OK, or if a fault is present on a specific battery bank. After fully charging and conditioning batteries, ProSport’s Energy Saver Mode will monitor and automatically maintain batteries in a full state of charge, resulting in maximum reserve power performance and lower AC power consumption and operating costs. ProSport incorporates Distributed-On-Demand™ Charging technology, taking 100% of the available charging amps and distributing them to any one or a combination of all batteries as needed for faster charging. Each ProSport model has 4 digitally selectable charge profiles including a once-a-month storage reconditioning mode for extending battery life.
The 12 Amp model is adequate for most systems with 2 battery banks each having 1 or 2 standard size batteries, for faster charging on larger battery banks choose the 20 Amp model.
|
Automatically Combines or Isolates Battery Banks, no more old fashioned 1, 2, Both switch!
This convenient and affordable kit gives you both an automatic charging relay and a dual purpose battery disconnect switch. The simple to use switch has 3 positions, OFF, ON, and COMBINED. OFF disconnects all loads from BOTH the engine and house batteries. ON connects the engine to the engine battery and the house loads to the house battery. Combined connects both batteries together to all loads to allow emergency engine starting from the house battery. Before now it took 3 switches and a bunch of wiring to provide these functions. The Automatic Charging Relays combines batteries during charging, but keeps them separated when not charging and during engine cranking (optionally), to protect sensitive electronics.
|
Automatically Combines or Isolates Battery Banks
The Mini Automatic Charging Relay (M-ACR) is designed to manage the charging current from alternators up to 65 Amps found on most outboards and many inboard engines to 2 battery banks. Start Isolation (SI) protects sensitive digital electronics with stored memory settings by temporarily isolating house loads from the engine starting circuit during engine cranking, protecting electronics from voltage sags and spikes. The compact design allows for three mounting styles: surface, rear, or panel mount.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Pole mounted steaming light, used on all M19 and some 92-93 26C. Plugged into socket near transom.
|
All vessels are required to display a white light visible in all directions whenever they are moored or anchored outside a designated mooring area between sunset and sunrise.
LED fixed mount all-around lighst are approved for USCG 2 nm (Colreg 2 mile). 12 Volt DC. Injection molded nylon/chrome plated zinc. Extremely low power draw.
Add an optional plug and pre-cut wire to plug this into your existing masthead (steaming) light socket (you won't need that one plugged in when you're anchoring!) NOTE: The old style deck plug used on most Mac boats until about 2009 is no longer available, you will have to change the boat half of the connector as well as the plug on the existing steaming light. The wire and plug option includes one complete connector assembly and one plug only. If you have a newer 26M with the new style connector (white plastic cover flap), you will not need to change the boat side of the connector.
Note: Because of the way the foam was inserted into the larger 26M masts (2003-2007) you will not be able to feed the wire through that mast to install lights or antennas at the masthead.
|
Navigation Light Requirements
Under sail at
night, light requirements:
The operator of a sailboat operating under sails at night
shall, from sunset to sunrise, display: sidelights (red - green) and. sternlight
(white). If less than 20 meters in length, the three lights may be combined at
or near the top of the mast.
Under power at night, light requirements:
The red light indicates a vessel's port (left) side; the
green indicates a vessel's starboard (right) side. Sternlight: This white light
is seen only from behind or nearly behind the vessel. Masthead Light: This
white light shines forward and to both sides and is required on all
power-driven vessels.
For use on masthead lights and stern lights, will work with any light except Aqua signal series 20 stern lights.
The light facing forward on the mast just below the
spreaders is the masthead light, for motoring at night.
• Tight fitting end caps slide to expand or contract the length of the bulb to fit many fixtures
• Highest quality components - really!
• High light output
• Reduces energy consumption — current draw of only about 0.1A
• Incredibly reliable — usually never need replacing
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Used on all models from 1992 till apx. 1998, screws to bow deck, does not mount on bow railing
If you'd like to add an LED Upgrade bulb you can add it as an option to this part, or use separate part number 8406-1V0 .
|
This screw-in style 4 pin connector should be more secure than the factory 2 pin. The mounting holes will not line up perfectly but should line up enough to make it work, or just secure it to the deck with some good marine sealant. Please disregard the picture that only shows 2 pins, this IS a 4 pin connector.
|
This screw-in style 2 pin connector should be more secure than the factory 2 pin. The mounting holes will not line up perfectly but should line up enough to make it work, or just secure it to the deck with some good marine sealant.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FOR POLE MOUNTED STEAMING LIGHT
|
This will fit in any of the bayonet style light fixtures for interior lights on MacGregors. These lights are about the same brightness and color of light as the factory incandescent bulbs.
Water tight Silicone Encapsulated BA15 LED. Large on light with but soft on the eyes. Equal to a 20W incandescent. • Latest Chip Technology • Water Tight • 10-30VDC Only, 2 Watt
|
metal strap to hold one group 24 battery. BOLTS NOT INCLUDED.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This is the switch replacement for the fuse panel.
|
Not sure what MacGregor parts to get for someone? Give the open ended gift of a Blue Water Yachts gift certificate. They never expire and are good for anything in our online store! Let us know how much you would like for your certificate and we can make it out for any price.
|
Stern light deck mounted, clear lens. This item is no longer manufactured, we do have a retrofit though! Replace with AQUA SIGNAL SERIES 25 STERN LIGHT AND BRACKET. Part numbers 8306-1V1 and 8702-1X1, respectively.
|
|
|
