|
|
|
|
|
|
|
|
|
|
|
|
|
Used from mid 1992 thru 1995. If your boat has heavy Stainless Steel mounting brackets for the centerboard that are exposed on the bottom of the hull, you need part # 5402-1C2, large hole centerboard. If your boat has no visible hardware on the bottom of the hull, and two access plates inside the boat to get to the centerboard pivot bolt (one under the galley, one to Port side of the galley), you need this part.
This centerboard is also available with a white gelcoated and polished finish instead of the standard grey barrier coat. The smoother board is more performance oriented.
This item uses $65 flat rate shipping, shown at checkout for domestic shipments. If this is shipping international it will probably not show the correct rate and we will have to contact you with the shipping amount after the order is placed. Canada is usually about $138, other countries will usually be higher than that.
|
Used from mid 1990 (early 1990 had daggerboard) thru mid 1992. If your boat has heavy Stainless Steel mounting brackets for the centerboard that are exposed on the bottom of the hull, you need this part. Later boats had no visible hardware on the bottom of the hull, and two access plates inside the boat to get to the centerboard pivot bolt (one under the galley, one to Port side of the galley). These boat use small hole centerboard part #5402-1C3. This is the standard grey barrier coat finish.
This centerboard is also available with a white gelcoated and polished finish instead of the standard grey barrier coat. The smoother board is more performance oriented. (The picture shows what the hardware looks like on the bottom of the boat for a "large hole" centerboard).
This item uses $65 flat rate shipping, shown at checkout for domestic shipments. If this is shipping international it will probably not show the correct rate and we will have to contact you with the shipping amount after the order is placed. Canada is usually about $138, other countries will usually be higher than that.
|
Used on early 26C with centerboard mounting hardware visible on the bottom of the boat, these boats do not have removable access plates under carpet or galley to get into ballast tank.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Early boats did not have a stop bracket to limit downward travel, these cables include stop a bracket and instructions for retrofitting stop bracket on early boats. The boat must be lifted off the trailer far enough for the centerboard to swing about half way down to replace this cable.
|
Use on late model 26C with through bolted centerboard. These boats have removable access plates under the carpet and under the galley to get access into the ballast tank Also used on all M19 models.
|
Replacement plastic cover for ballast tank inspection holes. Used on all but very early M19 and some 92 26C. Originals are usually destroyed on removal. Comes with 6 mounting holes drilled.
|
|
|
|
|
|
|
|
|
|
|
|
Not sure what MacGregor parts to get for someone? Give the open ended gift of a Blue Water Yachts gift certificate. They never expire and are good for anything in our online store! Let us know how much you would like for your certificate and we can make it out for any price.
|
|
|
