Home > MacGregor Boat Parts > MacGregor 19 (1992-1995) > Hull Hardware
Sort By:
Page of 1
RUBRAIL, FULL INSTALLATION KIT RUBRAIL, VINYL, 50 FT SECTION TRANSOM VALVE, SMALL, 1 1/2 INCH WITH HANDLE

Used for M19, 26S, 26D, 26X, 26M, and Tattoo boats. Sold only in 50' sections. This is very difficult to install and we recommend a professional to do the install work. Needs to be stretched very hard for proper installation so 50' is plenty to do the whole boat.

This kit also includes 2 fiberglass end caps and 3 cartridges of 3M 5200 Marine Sealant (in caulking gun style tubes), as well as 1 cartridge of 3M 4000 UV, which is applied over the top edge of the rubrail where the rubber meets the boat. This should be enough to reseal the new rubrail all around the boat.

Used only on boats 1992 and newer. We do not have the older style rubrail available.

Used for M19, 26S, 26D, 26X, 26M, and Tattoo boats. Sold only in 50' sections. This is very difficult to install and we recommend a professional to do the install work. Needs to be stretched very hard for proper installation so 50' is plenty to do the whole boat.

Used only on boats 1992 and newer. We do not have the older style rubrail available.

Fits all M19 and 26X thru mid 1997, Newer 26X and 26M use 3" valve.
TRANSOM VALVE, EXTENDER, M19 DECK PLATE, SCREW OUT 4 INCH INSPECTION PLATE, BALLAST TANK

fits m19

Used anywhere you want an easily removable weather tight access point. Often used to access fuel fill caps on 26X.

Replacement plastic cover for ballast tank inspection holes. Used on all but very early M19 and some 92 26C. Originals are usually destroyed on removal. Comes with 6 mounting holes drilled.
CABLE BOOT AND RING, 3" BALLAST, TANK DIPSTICK TUBE TRANSOM VALVE, HANDLE, METAL
CABLE BOOT AND RING, 3"
Our Price: $7.99
A rubber cable boot and mounting ring, sold together as a pair. This is a 3" diameter ring and can be mounted anywhere on the hull or transom, it is recommended that you use a marine sealant along with stainless screws when mounting this piece. Typically used with steering cables/controls or electrical wires. Dipstick tube to measure how much water is in your ballast tank.
Metal screw on handle for all transom valves. does not include extension rod. This handle is stronger than the plastic handle (H206-114) but not as corrosion resistant in salt water.
RUBRAIL, FIBERGLASS END CAP BALLAST VALVE HANDLE, PLASTIC TRANSOM VALVE, SEAL, 1 1/2 INCH

White fiberglass cap to cover aft end of rubber rub rail. Only used on boats 1992 and newer.

This handle is not as strong as the metal handle (H206-110) but is totally corrosion resistant. If you keep you valve properly lubricated so it moves fairly smoothly this handle will outlast the stronger metal one in a saltwater environment.

small round rubber seal for 1 1/2" transom valves
Gift Certificate

Not sure what MacGregor parts to get for someone? Give the open ended gift of a Blue Water Yachts gift certificate. They never expire and are good for anything in our online store! Let us know how much you would like for your certificate and we can make it out for any price.